Pro-Line Pro2 Speed Run Car (Kake)
I hope this configuration works. I again had to drop some more cash on parts. They should arrive next week, I hate waiting....grrr!!!
Changes so far:
Looking at the condition of my rear hub carriers and front steering blocks I can clearly see the toll speed running (and crashing) has taken on Kake. I always thought that aluminum parts were mostly for show, but in the case of steering parts and rear uprights, they are required. I received the M6 steering blocks from Tekno yesterday, but upon looking at their site FAQ section, i read that the X-01 is "a direct replacement for ours". So X-01 aluminum steering blocks it is! Looking at the Tekno steering blocks I realized that the Pro2 caster blocks will be way too small for the X-01 steering blocks, so now I have the X-01 aluminum caster blocks on order as well.
Current proposed configuration--->
FRONT 8mm Conversion:
Traxxas X-01 Caster Blocks (6832x)
Traxxas X-01 Steering Blocks (6439)
Traxxas X-01 Steering Block Screws (3642x)
Ofna HYPER SSTe Front CVD Stub Axle ***(any 8mm CVD stub axle should work just measure it's length from the inner bearing stop to the hole for the Wheel Hex Hub pin)***
Ofna 17mm Wheel Hex Hubs
Boca 8x15x5mm Ceramic Bearings (SMR158C-2RS)
Boca 8x12x3.5mm Ceramic Bearings (SMR128C-YS)
Various 8mm shims
REAR 6mm Conversion:
Proline Transmission Outdrives (6099-10)
Proline ProMT Alu. Rear Hub Carriers (6264-00)
Tekno 17mm Adapters for M6 Driveshafts (TKR1654-17)
Tekno M6 Driveshafts (TKR2210)
Tekno CV Rebuild Kit (TKR6856)
Boca 10x18x4mm Ceramic Bearings (SMR1018C-2YS)
Boca 6x11x4mm Ceramic Bearings
(SMR116C-2YS)
Various 6mm and 10mm shims
No comments:
Post a Comment